2
A. Remove spatula.
B. Remove the top
plate by carefully
sliding it forward
and out of the unit.
C. Remove the venturi
plate.
Steamer 625-50
2
revA
Printed in USA
0
910
© 200
3
6
Steamer
625-
A
Cleaning - Daily PM Tasks
The following equipment is required:
•
Detergent or Cleaner
•
Delimer/Lime Scale Remover
(as required)
•
Sanitizer
•
Clean sanitized towel
•
Protective (insulated) gloves
Top Cover
Top Plate
Venturi Plate
Spatula
1
While wearing protective gloves, remove the top cover by
pulling up and off the unit.
3
A. Wash top cover, top plate, and venturi plate in a solution of
detergent and water
.
B. Rinse with clean water, and then sanitize in a solution of
sanitizer
.
C. Let air dry.
6
Reassemble the unit.
Turn the unit on. When unit is preheated, run a minimum of
four cycles to prime the unit and remove any residual cleaner.
It is recommended that the steamers go through a deliming
procedure at least once a month. Some hard water areas may
require increased deliming based upon actual buildup.
WARNING
Turn the unit off and unplug the power cord from the electrical recep-
tacle. Proceed with caution, unit is still hot!
CAUTION
This unit is not watertight. Do not clean with a water jet/jet spray. Do
not immerse the unit in water.
Do not use abrasive materials such as scrapers, steel wool, etc. to
clean the spatula or steam chamber.
4
Wipe the steam chamber surface with a clean sanitized cloth.
OPTIONAL: If the surface shows
signs of excessive calcium and
lime buildup, dissolve two tea-
spoons of
delimer
in a
small coffee cup with 100mI of
water. Pour half on each side.
Using a clean sanitized towel,
wipe the internal surfaces of the
steam chamber. Allow to sit for
5 minutes. Using a clean sani-
tized towel,thoroughly rinse and
wipe, the internal surfaces of
the steam chamber.
5
Wash all external surfaces of the steamer with a solution of
detergent and water
. Using the
solution in a spray bottle
,
spray directly onto a clean sanitized towel and wipe the unit
clean.
While wearing protective gloves:
CAUTION
Do not spray directly on the unit or use abrasive cleaners!
