23
MECHANICAL INSTALLATION
TUMBLE DRYER
Locking nut
A
B
4
. Position the plastic cups so that the arrowed
lugs are flush with the
front and side of the
top, then press down
onto the top. Now
break off the remaining tabs.
5
. Slide the tumble dryer under the metal brack-
ets, keeping the front
edge raised 1–2 cm.
6
. Lower the front feet of the dryer into the
plastic cups and adjust the
feet so that the dryer is le-
vel.
ADJUSTING THE FEET
Screw the feet in or out until the dryer is steady
and level on the floor or washing machine. Then
tighten the locking nuts.
Fit the stacking kit as follows:
1
. Unscrew the two arrowed screws at the rear
of the washing machine.
2
. Fit the metal brackets as shown, using the
screws.
3
. The plastic cups that will hold the front feet
of the tumble dryer must be attached to the top
of the washing machine. This is important since
the feet of the tumble dryer must be located in
the plastic cups to ensure that the dryer is cor-
rectly positioned.
Break tab
A
off the cup that goes on the right
side and break tab
B
off the cup that goes
on the left side. Then
peel the backing paper off
the self-adhesive base of
the cups.
