Primus D55, Руководство по обслуживанию, Страница: 32 / 82

30
70276001
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
35. LOADING DOOR ASSEMBLY
Refer to Figure 5.
a. Open loading door until door is perpendicular
to machine front.
b. Remove bottom hex head screw from hinge
cam at bottom of door.
c. Remove lower cam assembly by sliding
downward while disengaging setscrew from
door hinge.
d. Lift door assembly off top of door hinge lug.
36. LOADING DOOR HANDLE
Refer to Figure 5.
a. Open loading door.
b. Remove hardware holding door handle to door.
37. LOADING DOOR SWITCH
Refer to Figure 6.
a. Open loading door.
b. Remove two screws holding switch cover to
front panel.
c. Disconnect wires from door switch.
d. Remove switch from cover by removing two
nuts and screws.
NOTE: Switch must be flush to underside of cover
at button protrusion and flats of hex nuts must be
parallel to cover underside when reassembling.
NOTE: Refer to wiring diagram when rewiring
switch.
To reduce the risk of serious injury or
death, loading door switch MUST be
reinstalled after service is completed.
W328
WARNING
Figure 5
TMB1792S
TMB1760S
Hinge
Door
Handle
Door
Switch
Loading
Door
Loading
Door
Washer
Nut
Door
Strike