Primus 5kg, Руководство по установке и обслуживанию, Страница: 10 / 33

8 USER'S MANUAL 516574_C_PUB_DATE_3_NOV_2009.DOC
FAILURE 14: HEATING TIME FAILURE
When after 75 minutes the target temperature is not reached (for a machine set as wait for heat):
Message 14 will be displayed.
DIAGNOSE:
1. Check if the heating resistors are heating
If the heating resistors are not heating:
Repair the wiring or replace the defective resistors
2. Check the water temperature If the hot water temperature is too low: increase the
temperature of the hot water
3. Check if the temperature sensor is
functioning
If the temperature sensor is defective : replace the
temperature sensor
FAILURE 16: COIN BLOCKING 1
When the input for coin drop 1 is blocked for more then 5 seconds: message 16 will be displayed.
Case EP = ON.
Fault 16 will be displayed if the external start release signal is high for more then 10 seconds when the door
has been opened at the end of the program.
DIAGNOSE:
1. Check the well functioning of coin drop 1. If the coin drop micro contact or optocoupler is not
functioning 100%: replace the coin drop.
2. Check the continuity of the wiring. If the wiring is not continue : repair the wiring.
FAILURE 17: COIN BLOCKING 2
When the input for coin drop 1 is blocked for more then 5 seconds: message 17 will be displayed.
DIAGNOSE:
1. Check the well functioning of coin drop 2. If the coin drop micro contact or optocoupler is not
functioning 100%: replace the coin drop.
2. Check the continuity of the wiring. If the wiring is not continue: repair the wiring.
FAILURE 99: SAFETY ERROR
When Error 99 occurs this is a main error message to prevent that the door can be opened.
On the lower display instead of Err, the temperature value is displayed.
Causes :
* If at the end of the wash cycle :
- if there is still water in the tub, it’s not allowed to open the door.
- if the temperature in the tub is too hot (water ?), it’s not allowed to open the door.
If the problem disappears also Error 99 will disappear and the door can be opened.
* If there is a problem with the door lock system during the wash-spin cycle :
- the wash-spin cycle is interrupted at once and the machine will keep the door locked.
- Error 99 can only be removed by manual intervention (keyswitch in setup mode and pressing the
SET button). As a result a new error number that corresponds with the door lock problem will be
displayed. The door will only be unlocked after manual intervention.
ATTENTION!
BEFORE EACH INTERVENTION WAIT UNTIL THE TEMERATURE HAS REACHED A SAFE VALUE!
DIAGNOSE:
Check the Diagnoses like for error messages 2, 6, 7 or please contact the your supplier for more technical
assistance.
FAILURE 6-10 / 12 / 15 / 18-90 / 100-180
Please contact the your supplier for more technical assistance
!