Primos 63063, Инструкция по эксплуатации, Страница: 12 / 19

13
October 6, 2015 and the time is 10:38 AM, you would enter this:
“TIME”201510061038. Note that the time format is 24 hour, not
12, so enter the hour of 1:00 PM as “13”, etc.
4. Under the File menu in TextEdit, select “Save As”, and select the
SD card slot or reader as the save location. If you don’t see it in the
“Where” list, click the down arrow to the right of “Save As” to see
a complete list of Devices-the SD card should be on there. Make
sure the File Format is “Rich Text Format”
(.rtf)
. Name the TextEdit
file “TIMESYNC” and click Save to save it to the SD card.
5. Eject the SD card (right click, select “Eject (name of card)_”, and
wait for the card icon to disappear from your Mac desktop).
6. Make sure the Primos cam’s power switch is off. Insert the SD card
into the camera’s card slot, then switch on the camera. Test the
date imprint by waving a hand in front of the camera a few times
during a minute or two.
7. Switch off the camera and remove the card. Insert the card in
your Mac’s card slot or USB card reader. Double click to view
the card contents. The .jpg photos or .avi videos are in the DCIM
folder. Open a few to verify that the correct date and time are
being imprinted at the bottom of each photo.
8. If the correct date and time are not imprinted on the photos,
repeat these steps exactly as written. The SD card can be
reformatted (erasing all previous contents) on your Mac by using
the default Disc Utility app. Select the name of the card, select
“Erase” and select the Format “MS-DOS (FAT), then click “Erase…”
POWER ON / MODE SELECT
After inserting batteries and an SD card (w/date & time file at your option) ,
slide the power switch to the PIC (Picture) position if you wish to capture
still photos, or all the way up to the
MOV
(Movie) position if you prefer to
capture videos. The PIR/Battery and Operating Status indicator lights(LED
below Primos logo) will warn of problems with the SD card or battery.
• If the Operating Status indicator LED (pg. 9) blinks, there is a problem
with the SD card. Check the card (make sure it’s inserted correctly
and protect switch is not locked) or switch to a new card if it is full.
• If the PIR/Battery indicator LED (pg. 8) blinks, battery power levels
Primos 63063 BulletProof2 Cam_1LIM_rev5.indd 13 1/20/16 2:14 PM