Model # 900138: Page 8
Dispensing Hot Water
This unit dispenses water at temperatures that can cause severe burns. Avoid
direct contact with hot water. Keep children and pets away from unit while
dispensing. Never allow children to dispense hot water without proper and
direct supervision. Unplug unit to prevent unsupervised use by children.
Note: After setup, hot water will be available in 15-20 minutes.
1. Position bottle, glass, pitcher or cooking pot securely below hot water tap.
-
The gray arrowhead below the hot water control indicates the location of the
hot water tap.
-
The circular shapes in the drip plate help align the flow of water. This unit
dispenses water at a fast rate. To avoid splashes, hold cup as close to the tap
as possible.
2. Push red hot water release inward and depress hot water control downward to start
flow.
3. Release hot water control once desired fill level is achieved.
Replacing an Empty Bottle
Notice: Replace bottle as soon as you notice it is empty.
1.
Lift bottle straight up to disengage from the bottle probe.
2.
Remove tamper seal from top of bottle cap of fresh bottle. Do NOT remove plastic
cap.
3.
Clean bottle cap and neck with a soft cloth and warm soapy water, then rinse.
4.
Lift bottle and insert onto the probe. Apply slight pressure until the plug inside the
cap pushes in and the bottle is seated. Water will begin to flow into the reservoirs
causing air bubbles to form in the bottle.
