Timer Switch Control Installation
Digital Elapsed Timers and Code Blue Timers include a Timer Switch Control that controls the timer functions.
Installation requirements
(1) Timer control switch (supplied)
(1) Cable connector (supplied). Telephone cable with an RJ-11 connector. The cable length can be extended up to 100 ft. (30.4
meter). Required to connect timer control switch to timer unit.
(1) Single-gang junction box (not supplied). Recommend use of a 2¼ inch x 2¾ inch x 4 inch. (5.72 cm x 6.99 cm x 10.16 cm)
junction box.
How to install Timer Switch Control
1. Wire the code blue timer input to the code blue system. Wiring is determined by the code blue system as specified below.
l
Code blue systems that apply a voltage to start a code blue event: wire the timer 4 pin connector's RED (Positive Code Blue
Input) and BLACK (Negative Code Blue Input) wires to the code blue system. Cap off the WHITE and GREEN wires separately.
An input voltage of 5-120V (AC or DC) can be used. When using DC, be sure to use the correct polarity; RED wire is positive
and the BLACK wire is ground. Code Blue start and stop events are triggered by the application of voltage across the code blue
input wires.
l
Code blue systems that use a dry contact and do not inject a voltage: wire the timer 4 pin connector's GREEN (Ground) and
BLACK (Negative Code Blue Input) wires together and wire the WHITE (12VDC) and RED (Positive Code Blue Input) wires to the
code blue system dry contact.
3. Connect the timer control switch to the timer using the supplied cable.
4. Securely mount the timer control switch into a single-gang junction box.
NOTE
The timer control switch membrane and wall plate may be cleaned with water or most common disinfectants. Be sure to
test any cleaning solutions on a small area.
Timer Switch Control wiring specifications
38
XR Levo Series Digital Clocks/Timers Install Guide
Содержание XR Levo Series
