PRIMERGY BX600 S3, Руководство по оборудованию

Страница: 64 / 143

64
Chapter 5 CLI
5.1 CLI Connection Methods
This chapter explains CLI connection methods using Telnet via LAN or a serial
interface.
When using CLI via LAN using Telnet it is recommended to use the following
software.
• RemoteControlService V3.06 or later
5.1.1 Using Serial Interface
1
Connect Management Blade to the management terminal using an RS-232C
cross cable.
"
■
Serial Interface Settings" (p.18)
2
Start the terminal software in the management terminal and perform the
following port settings.
3
Sets the terminal software of the management terminal to [VT100].
For more details about how to set terminal software, refer to the manual supplied with the
terminal software.
Connect the Management Blade operating in master mode.
A Management Blade in slave mode cannot be accessed.
Check the operation mode of the Management Blade with the Management Blade
master display LED ( "1.2 Component Names and Functions" (p.11)).
Parameter Setting
Bits/sec. 115200
Data bit
8
Parity None
Stop bit 1
Flow control None