Creating Discs
11
Section 2: Creating Discs
There are two main components to creating discs, printing and
burning. For PC, SureThing CD Labler is used to design the
image to print on the disc. For Mac,
Disc Cover
is used to
design the image to print on disc. For Mac and PC,
PTPublisher controls the recording and allows you to select the
image to be printed to your discs.
A. TUTORIAL: COPY A DISC
Note:
PTPublisher functions virtually the same on both Mac and PC.
Every effort was made to make them look and function the same.
However, due the unique benefits and limitations of both operating
systems there are subtle differences. Where important, those
differences will be highlighted. In general, these instructions will
apply to both the Mac and PC editions.
There are three basic steps to any project. 1. Add Data 2. Add
a Print File. 3. Set the number of copies and adjust options
(Summary). The instructions below explain how to do the
most common project - A Copy Project.
A
Copy Project
can be used to copy any CD, DVD, DVD-DL
or Blu-ray master. This job type reads the master disc from the
Disc Publisher drive to the hard drive of your computer.
The master is stored in the Global Image format (*.gi) in a
temporary location on your computer. PTPublisher uses this
temporary file to make all subsequent copies that are
requested. The master disc is read only once to create the
initial temporary file.
Recommended for: All CD, DVD or Blu-ray content or disc
types (Audio CD, Data CD, Software Install Disc, Video CD,
DVD Video, Blu-ray Video: CDR, DVD-R, DVD+R, DVD-ROM,
DVD+DL, DVD-DL, BDR, BDR-DL, etc.). This is best used for
single runs where you will not need to make additional copies
of the master disc at a later time.
This project requires a master disc. If you do not have one
use another project type. (See Section 3B)
XRP.qxd 4/18/2011 2:55 PM Page 11
