To Turn Off Valet Mode
1. Connect the coded tag to your key chain.
2. Turn the ignition key to the "ON" position.
3. Open and close the driver door.
4. Turn the ignition key OFF and then ON three times (OFF, ON, OFF, ON,
OFF, ON). The LED will turn off to indicate the AMX28 is out of Valet Mode.
Adding/Deleting Coded Transponder Tags
1. Enter the vehicle and close the door.
2. Disarm the Immobilizer. (Turn the ignition key ON with your coded tag on
the key chain.)
3. Remove all transponder tags from the key ring.
4. Turn the ignition key ON, OFF, ON, OFF and then ON. The LED will
begin to flash rapidly to indicate the AMX28 is now in the programming
mode.
5. Hold one of the transponder tags close to the ignition switch. The LED will
change from a rapid flash to slow single flashes to indicate the AMX28 has
learned the one transponder tag. Remove the coded tag from the ignition
switch area.
6. Hold the second transponder tag close to the ignition switch. The LED will
flash slowly two times to indicate the second transponder has been learned
and that there are now two transponder tags in memory.
7. Repeat steps 3 and 4 for any other transponder tags you wish to add to the
AMX28 memory. (You can add up to 5 tags.)
8. When you have finished adding the transponder tags into memory, turn the
ignition key to the "OFF" position to exit programming.
NOTE: Any transponder tag(s) that were not used in this process will be
automatically deleted from the AMX28 memory and cannot be used to
deactivate the Immobilizer.
Part Number: 31-3325
2
