Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
3
ASH-8034 ASSEMBL
Y
INSTR
UCTIONS
1–3
M8 Locknut
Bottom Connector
WorkPro Light Holder
M8 x 25MM Bolt
Nylon Washer
” Flat Washer
Bottom Connector
WORKPRO LIGHT MOUNT
INSTALLATION SEQUENCE
NOTE: The Gen4 PBR Rack and WorkPro LED
Light shown in this Manual are for illustrative
purposes only, and are not included in this Kit.
This Light Mount Kit contains only the parts
needed to repair, replace, or retrofit one Light
Mount. Order an additional kit for the other to
add an additional accessory light.
1.1
1.2
Attach the Bottom Connector to the light holder as
shown below and torque to 90 in-lbs.
NOTE: With certain
WorPro models,
you may have to
move the light
holder in order to
install the M8 Bolt.
(Remove any
exisiting bolt
hardware from
the center hole)
Torque Bottom Connector Hardware to 90 in-lbs
BOTTOM CONNECTOR
