Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
4
PLR-8229 ASSEMBL
Y
INSTR
UCTIONS
USAM-PLR8229-US01 Rev-B 0619
3
Install Clamp base with the included M8 Hardware
into the DeployPro’s pre-installed Strip Nuts as shown.
Determine desired positioning on the DeployPro,
and torque to 90 in-lbs.
4
Position your ladder
back onto the Deploy Pro.
Install the Z-Posts onto the
ends of the Clamp base
as shown below.
6
Using the release levers,
slide the Clamp base
together into the closed
position on the ladder.
6.1
Slide Z-Posts in until they are approximately ¼” from
the sides of the ladder, and torque the Z-Post Clamp
Nuts to 90 in-lbs.
¼” from ladder sides
NOTE: Ladder Straps will no longer be necessary,
and may be discarded.
5
Finger-tighten Clamp Nuts only.
Do not trorque until Step 6.1
