Primare A30.5, Руководство пользователя

Страница: 8 / 10

>
Connecting the A30.3 Amplifier
4
P O W E R C O N N E C T I O N
Warning : Before connecting power check that the required supply voltage,
indicated on the back panel, corresponds to your local AC supply. If a
different voltage is stated on the type plate do not connect the amplifier to the
mains power, and seek advice from your dealer.
Connect the mains power using the enclosed mains cable.
Note: Always disconnect the amplifier from the mains power before
connecting or disconnecting any of the cables.
Switching on
The mains switch is on the base plate at the front, to the left under the front
plate. After the switch is activated, the indicator on the front panel lights up
green.
O U T P U T S
Loudspeaker outputs
Connect the loudspeakers for each channel to the corresponding terminals.
The terminals can accept speaker cables terminated with 4mm banana plugs,
spade terminals, or bare wires. To connect bare wires unscrew the terminal,
pass the bare wire through the hole in the terminal bolt, and clamp the wire in
place by screwing the terminal back down.
I N P U T S
Connect the A30.5 to each channel of the preamplifier or processor using the
corresponding phono inputs, using high quality phono leads.
R E M O T E L I N K
To power the A30.5 on and off remotely from a Primare P30 Processor
connect the REMOTE output from the P30 Processor to one of the REMOTE
LINK sockets on the A30.5, using a twin core cable terminated in 3.5mm jack
plugs. The second REMOTE LINK socket can be used to daisy-chain the
remote output to further A30 series amplifiers.
Note: Ensure that the P30 is switched off before connecting it to the A30.5
with a remote link cable.
To use the remote link, switch the REMOTE SW switch to the ON position.
§2 Connecting 19/2/01, 11:30 am 4