Distributed by Tahsin Industrial Corp. USA 685 Route 10 East, Randolph, NJ 07869
CLIMBING INSTRUCTIONS
CAUTIOUSLY
put your weight on the foot platform.
The additional weight will create tension on tree strap cables.
NOTE:
Images used are for demonstration purposes only and may not depict the actual product.
Have both top and bottom platforms
angled down towards base of tree to
compensate for a smaller tree
diameter at desired hunting height.
FIG.1
FIG.2
C
O
FIG.3
Before beginning to climb: Check that your harness is secure, check that cables are properly quickclipped,
and make sure that the seat straps on your seat section are off to the side, they should not obstruct the
cable connecting to the tree in anyway while climbing.
Practice at ground level with you Full Body Harness.
Familiarize yourself with this product’s function so you feel comfortable with the climbing procedure.
1. Lean on shooting rail and lift your feet to raise foot platform. Push down to set foot platform
in raised position.
FIG.1
2. Stand and lift up on seat platform to adjust it to a comfortable level. Push down to set seat
platform in raised position. Raise your harness tether to take up the slack.
FIG. 2
3. Again, sit on shooting rest and lift you feet to raise foot platform. Push down to set foot
platform in raised position.
FIG.1
4. To continue climbing up tree, repeat steps 1 through 3. Continuously adjust your harness to
keep strap above your head with minimum slack.
5. When you have reached the desired height to hunt from, wrap each Climber Buckle
O
around each cable in the front of the tree.
FIG.3
Thread the strap through the buckle and pull
tight.
(See Buckle Instructions)
. The straps should be in front of the tree and
NOT
wrapped
around the tree. Pull excess slack through buckle, this will lock the platforms into place on the
tree.
6. Carefully remove one foot at a time from the foot straps. Slowly turn around never taking both feet off of the foot platform, you
MUST
always have weight pressed on the foot platform.
7. Sit on the seat cushion, if any adjustment needs to be made to the seat placement, you
MUST
climb back to the ground and adjust on the
ground. Using a safe hoist/lift system, raise your unloaded weapon.
8. To climb back down the tree, reverse the process, always ensuring you are constantly adjusting your harness tether as you move.
©2013 (rev. 12/12)
CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
WWW.TREESTANDCUSTOMERSERVICE.COM
