Distributed by Primal Vantage Company Inc. 685 Route 10 East, Randolph, NJ 07869
13. Raise the Roof Assembly to the tree using a safe
hoist/lift system to 3 feet above the shooting rail of your
treestand.
G
N
H
N
Pull strap to desired
length.
BUCKLE STRAP INSTRUCTIONS
Hold buckle as shown
Press down on latch and
insert strap underneath
teeth as shown.
Pull slack to tighten.
Wrap the Buckle Strap around
the back of the tree and insert
the strap through the buckle.
Make sure that the strap is flat
against tree with no slack.
Thread the buckle strap
through one end of the bracket
Pull strap over the top of the
bracket, then through the
other side of the bracket.
Pull the strap all the way
through so the buckle end is
against the bracket. The straps
will be attached to the bracket
and hang freely until ready to
be secured to the tree.
14. Attach the Vertical Support to the tree by using the two
Buckle Straps
N
. Insert one end of the strap through
Bracket
G
that is attached to Top Tree Brace
E
. Wrap
the strap around the tree once and insert the other end
into the buckle.
(See Buckle Strap Instructions).
Pull
strap until it is tight against the tree. Attach the other strap
to Bottom Tree Brace
H
, by following the above steps
and the Buckle Strap Instructions.
You
MUST
use a Hoist system to lift the
Roof to the Stand for installation
DO NOT
climb the Ladder with the Roof
and Blind in Hand
W A R N I N G
NEVER
stand on seat platform to attach roof.
Raise flip-up seat platform to move closer to
tree.
W A R N I N G
CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
WWW.TREESTANDCUSTOMERSERVICE.COM
ASSEMBLY INSTRUCTIONS PAGE 7
MODEL: HEH00591
OUTPOST ELITE KIT
©2012 (rev. 04/12)
