www.primacoustic.com
INSTALLING CORNER BASS TRAP PANELS
Primacoustic corner impalers make it easy to mount the 24” x 48” Broadband panels across room
corners to form effective bass traps. Like the surface impaling clips, the corner impalers feature sharp
tips that penetrate the panel and hold it securely in place.
Step 1:
At the approximate panel location mark a vertical pencil line 17” (432mm) out from the corner
on either side.
Step 2:
Mark the screw/anchor locations for corner impalers along the edge of the pencil line. Corner
impalers should be approximately 6” - 8” from the panel top/bottom edges.
Step 3:
Install the included wall anchors for each corner impaler. Using the 1/4” bit, drill a 1.75” (4.5
cm) deep hole and insert the plastic anchors. Use the included screw to mount the corner impalers.
Special holes in the impaler clips allow your screw driver to pass through.
Step 4:
Once the corner impalers are in place, carefully rotate the sharp impaling tips so they all point
up at a 45° angle.
Step 5:
Lift the panel so it is in contact with all of the corner impaler tips. Once you have it lined up
squarely, apply even pressure in and down onto the clips. The panel will sink down about one inch. If
alignment is off, the panel may be nudged up to ¼” to make it level.
17” (432mm)
17” (432mm)
2
3
4
5
1
17” (432mm)
Primacoustic is a division of Radial Engineering Ltd. 1588 Kebet Way, Port Coquitlam, BC Canada V3C 5M5
Tel: (604) 942-1001 • Fax (604) 942-1010 • [email protected]. Specifications and appearances subject to
change without notice. Copyright © 2020, all rights reserved.
