SETTINGS
There are 3 settings
1
,
2
and
Pulse
Setting
1
is low speed and is usually best for soft fruits such as plums and peaches (Please
remove the stone before trying to juice!)
Setting
2
is faster and is usually best for harder fruits such as apples and carrots.
Setting Pulse gives short, powerful blasts.
PLEASE NOTE
: There is a temperature safety device installed in the machine. If the machine
becomes too warm the machine will automatically shut down until the motor has cooled to the
correct temperature. (This usually takes about 5 minutes). To prevent this from happening
please do not use the machine continually for more than two minutes at a time.
Juicing
1. Clean parts and assemble the machine as described above.
2. Make sure the switch on the machine is set to ‘0’ and connect to mains supply.
3. Remove the Juicer Stick (it simply lifts out).
4. Ensure the juicer and pulp containers are in place.
5. Wash and cut fruit into small pieces that will fit through the feeding tube.
6. Start the machine using the power switch and turning it to position 1 for slow and position
2 for fast.
7. Slowly add the fruit/vegetable pieces via the food chute using the Juicer Stick to feed the
fruit down the chute. Please remember to remove any stones in fruit or any peel that you
would not normally eat.
8. The juicer is efficient but do not to over load the machine by feeding too much through at
once.
9. Once the juice container is full you can empty the juice into another container and then
resume juicing.
10. Once the Pulp container is full, switch of the juicer at the mains supply and disassemble
as described above. Empty the pulp from the pulp container and re-assemble as
described above. Switch on the mains supply you can now continue juicing.
11. Notes: The amount of juice produced depends upon the type of fruit/vegetable used and
how ripe it is. Only put through things that you would normally eat, for example: Kiwi fruit
should be peeled first. Never put sharp objects down the food chute or fruit with a hard
shell.
Please note
that bananas are not suitable for juice extractors due to the way the fruit is
structured.
Cleaning
When cleaning this product please observe the following precautions:
•
Always ensure the unit is switched off & unplugged from the mains
•
Disassemble as described in the disassembly instructions.
All parts except the Main Body (9) can be washed with warm soapy water, rinsed and dried
thoroughly.
To clean the Motor Block (9) wipe with a soft damp cloth. DO NOT IMMERSE IN WATER OR
PLACE IN THE DISHWASHER. THE MOTOR BLOCK CONTAINS THE ELECTRICAL
COMPONENTS.
