Prima PH50D8, Руководство по обслуживанию

Страница: 3 / 46

- 1 -
Note:
This maintenance manual is intended only for the reference of the maintenance people. Please
pay attention to the following points before carrying out the maintenance work.
Safety Instructions
Please read the “Points for attention for the Maintenance & Repair of PDP”and “Criterion for Identifying
the Defects on Screen” as below, before inspecting and adjusting the TV set.
1. “Points for attention for the Maintenance & Repair of PDP”
To avoid possible danger, damage or jeopardy to health and to prevent PDP screen from new
damage, the maintenance people must read the following carefully. If they ignore the following
warnings, there will be deathful risks:
1). Screens vary from one model to another and therefore not interchangeable. Be sure to use the
same type of screen in the replacement.
2). The operation voltage is approximately 350v for PDP module (including screen, driving circuit,
logic circuit and power module). If you want to conduct maintenance work on PDP module
when the set is in normal operation or just after the power is off, you must take proper
measures to avoid electric shock and never have direct contact or touch with the circuitry of
the working module or metal parts. That’s because within a short time relatively high voltage
still remains on the capacitor of the driving part even after the power is off. Make sure to begin
relevant maintenance operation at least one minute after the power is off.
3). Don’t apply on the module any power supply that is higher than the specification.
If the power supply used deviates from the value given in the specification, there might be a
possibility of leading to fire or damage to the module.
4). Never have operation or mounting work under unsuitable environment such as areas in the
vicinity of water – bath room, laundry, water chute of kitchen – sources of fire,
heat-radiation parts or direct exposure to sunlight. Otherwise there will be kickbacks.
5). In case foreign substances such as water, liquid, metal slices or others fall into the module
carelessly power must be cut off immediately. Keep the module as it is and do not move
anything on the module. Otherwise it might be possible to contact the high voltage or cause
shock short circuit so that it may lead to fire or electric shock.
6) If there is smoke, abnormal smell or sound from the module, please cut the power off
immediately. Likewise in case the screen doesn’t work when the power is on or during the
operation, please also cut off the power at once. No more operation in this case.
7) Do not remove or plug its connection wire when the module is in operation or right
after the power is off. That’s because there remains a relatively high voltage on the
capacitor of the driving circuit. If there is a need to remove or plug in the connection wire,
please wait at least one minute after the power is off.
8). Considering the module has a glass faceplate, please avoid extrusion by external force lest it