SETUP FOR: PS3
™
1. Charge the Freedom 1 Wireless headset before use.
To charge, connect one end of the micro-USB
cable to the headset and the other end into one
of the USB ports on your PS3
™
system. Once the
headset is fully charged, disconnect the micro-USB
cable. Charging takes approximately 2 hours.
2. Plug the USB dongle into one of the free
USB ports on your system .
3. Switch the Freedom 1 headset ON. If pairing does
not happen automatically, (indicated by a solid red
LED on both the dongle and headset), hold down
the power button until the LED on the dongle starts
to flash. Once they both become solid, pairing is
complete. (This should be a very fast process.)
4. To setup the Freedom 1 as the main audio input for
chat, access the XMB
™
menu, and go to : Settings >
Accessory Settings > Audio Device Settings > Input
Device. Select the Freedom 1 and from here you
can change the sensitivity of the microphone.
5. In addition, to make sure that all chat sound goes via the
Freedom 1 go to : Settings > Accessory Settings > Audio
Device Settings > Output Device. Select the Freedom 1.
6. Use the Voice Monitor button to toggle on
and off the ability to hear yourself.
7. Use the mute slider to toggle the microphone on and off,
so you can control when other players can hear you.
8. Use the volume controls on the side of the Freedom 1 to
cut or boost the volume of the speaker in the headset.
At maximum volume you will hear a beep tone.
9. When the Freedom 1 is running low on battery (which
can affect performance) you will hear a beep tone
every minute.
12
11
