INSTALLATION INSTRUCTIONS
1. HANDLE INSTALLATION
a. Loosen both knobs on the handset.
b. Squeeze the crocodile clip on the handset
and apply to the push handle as shown.
c. Secure the clip by turning the outer knob
clockwise.
d. Tilt the handset to the required angle then
tighten the inner knob clockwise to secure.
2. BRACKET INSTALLATION
a. Install both brackets on the bottom horizontal
tubing of the wheelchair, using an Allen Key.
b. Ensure that the screws are sufficiently tight
and do not rotate on the tubing.
3. POWERPACK INSTALLATION
a. Feed the telescopic bar through the front
end of the PowerAssist. Loosen the tristar
knob on the bar and adjust to the correct
length
b. Tighten the knobs on the bar and at the
front of PowerAssist.
c. Place the two ends of the bar on the rear of
the Brackets, then push the powerpack
forward until it locks in position.
