What if my Jazzy Select 14/14XL begins pulling to one side?
Determine if the joystick is being deflected straight or at a slight angle.
Even a small amount of deflection
right or left will cause the chair to veer over a long distance.
Determine if both manual freewheel levers are in the drive position.
If only one manual freewheel lever
is in the drive position, the other motor will not operate and the Jazzy Select 14/14XL will veer severely.
Determine if both tires are inflated to the proper psi if the power chair is equipped with pneumatic tires.
Maintain but do not exceed the psi/bar/kPa air pressure rating indicated on each tire if equipped with
pneumatic tires. If one tire is inflated more than the other, the power chair will pull to the side that is
underinflated.
NOTE: If the tires on your power chair list the psi rating only, use the following conversion formulas to find
the bar or kPa rating: bar = psi x 0.06895; kPa = psi x 6.89476.
What if the Jazzy Select 14/14XL powers up, but will not move?
Determine if both manual freewheel levers are in the freewheel position.
If the power chair is in freewheel
mode, then the electronics will function but the motors will not spin the wheels.
Determine if the controller is flashing a fault code.
The Jazzy Select 14/14XL comes equipped with a VSI,
VR2, or Dynamic controller. The VR2 and VSI controllers will flash a code via the battery condition meter
LEDs if a system fault is detected.
The Dynamic controller error codes are displayed by a flashing service
indicator.
VR2/VSI DIAGNOSTIC FLASH CODES
# OF LEDS
CODE
CAUSE
POSSIBLE SOLUTION
One red LED
1
Low battery voltage
Charge batteries
Two red LEDs
2
Left motor open
Make sure left motor is plugged into controller.
Three red LEDs
3
Left motor wiring fault Contact your authorized Pride Provider.
Three red LEDs
One yellow LED
4
Right motor open
Make sure right motor is plugged into controller.
Three red LEDs
Two yellow LEDs
5
Right motor wiring fault Contact your authorized Pride Provider.
Three red LEDs
Three yellow LEDs
6
Inhibit active
Contact your authorized Pride Provider.
Three red LEDs
Four yellow LEDs
7
Joystick error
Contact your authorized Pride Provider.
Three red LEDs
Four yellow LEDs
One green LED
8
Controller error
Contact your authorized Pride Provider.
Three red LEDs
Four yellow LEDs
Two green LEDs
9
Brake fault
Make sure both motors are plugged into controller.
Three red LEDs
Four yellow LEDs
Three green LEDs
10
High battery voltage
Contact your authorized Pride Provider.
2
www.pridemobility.com INFINFB2048/Rev. B/November 2008
B
ASIC
T
ROUBLESHOOTING
I
NSTRUCTIONS
: J
AZZY
S
ELECT
14/S
ELECT
14
XL
