Pride i-Go, Руководство пользователя

Страница: 15 / 20

●Find a spacious place like square and have an assistant to help you
practice until you have enough confidence to operate it by yourself .
●Be certain to shut down the power when you transfer in- or out of the
chair, and adjust the speed through speed adjustment button.
●We recommend you set the lowest speed until you can operate the
electric wheelchair skillfully .
● T o Practice the stop operation, forward and backward. Push the handle,
the wheelchair move to anywhere you want.
●Firstly, ensure that it is the lowest speed when practice forward
operation. After Skilled, you can practice “S” shaped turn. After you are
familiar with "S" shaped turn, to practice backward operation, and pay
attention to the speed control setting. And the backward speed should
lower than forward speed.
WARNING!
Do not use your wheelchair unless getting help from your
assistant when the wheelchair is in manual mode. Otherwise
it may result in personal injury.
Do not set your wheelchair in manual mode by yourself while
you are seated in the wheelchair. Otherwise it may result in
personal injury. In this case, please ask your assistant to help you.
Do not set your wheelchair in manual mode when it is on an
incline. Otherwise, the wheelchair could be out of control to
roll down by itself, and result in personal injury.
LED display Fault Diagnosis Troubleshoo�ng Remark
1 LED lamp flashes Ba� y ti c a p a c w o l s i y r e charge the ba�ery
2 LED lamp flashes The le�
le�
motor failure Check the motor and wiring harness
3 LED lamp flashes The brake failure Check if the brake lever is in the
correct posi�on, and if there is
damage for brake
4 LED lamp flashes The right motor failure Check the motor and wiring harness
5 LED lamp flashes The right brake failure Check if the brake lever is in the
correct posi�on, and if there is
damage for brake
6 LED lamp flashes Overload of the controller Check if the brake is released, and
wheels are locked.
7 LED lamp flashes Failure of the joys�ck Check if the rocker of controller in
the central posi�on
8 LED lamp flashes Failure of the controller itself Controller fault
9 LED lamp flashes Failure of the controller Controller fault
8. Safety devices and accident treatment
8.1 Circuit breaker: Refer to instruction manual 6.1.4
8.2 Safety belt:Refer to instruction manual 6.1.5
8.3 Please release the joystick whenever there is wheelchair fault ,
the wheelchair will be stopped.
7. Fault Diagnosis and T roubleshooting
For your convenience,this product has an automatic fault warning
function . Once it malfunctions, the LEDs on the controller will flash
with alarm sounded by the horn. Y ou can find where a fault is
according to information in T able 2.
If the fault is still showing after checking out the fault based on that
in table 2, do not use the wheelchair. Please turn off the power and
consult your service agent immediately .
6.1.4Circuit breaker
The circuit breaker, which is located in the battery box, is set for the
wheelchair’s safety. Once motors or batteries overloaded, the circuit
breaker will trip to cut off the power. After one or two minutes, it will
automatically reset and then you can continue to drive the
wheelchair.
6.1.5 Lap belt
For your safety, the lap belt must be fastened before you drive the
wheelchair.
6.2 Operation
6.2.1 Precautions for operation
13
14
V . OPER A TION V . OPER A TION
left
backward
right
forward