Pride Elite Trsveller, Руководство пользователя

Страница: 37 / 44

37
Elite Traveller www.pridemobility.com
I X . C A R E A N D M A I N T E N A N C E
Your Travel Scooter requires a minimal amount of care and maintenance. If you do not feel confident in
your ability to perform the maintenance listed below, you may schedule inspection and maintenance at
your authorized Pride Provider. The following areas require periodic inspection and/or care and
maintenance.
TIRE PRESSURE
If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure indicated on each tire.
WARNING! It is important that the psi/bar/kPa air pressure indicated on each tire be
maintained in pneumatic tires at all times. Do not underinflate or overinflate your tires.
Low pressure may result in loss of control, and overinflated tires may burst. Failure to
maintain the psi/bar/kPa air pressure indicated on pneumatic tires at all times may result
in tire and/or wheel failure.
Regularly inspect your Travel Scooter’s tires for signs of wear.
WHEEL REPLACEMENT
If your Travel Scooter is equipped with pneumatic tires and you have a flat tire, you can have the tube
replaced. If your Travel Scooter is equipped with a solid tire insert, either the solid insert or the entire
wheel must be replaced depending on model. Contact your authorized Pride Provider for information
regarding replacement wheels for your Travel Scooter.
WARNING! Wheels on your Travel Scooter should only be serviced/replaced by a qualified
technician.
WARNING! Be sure that the key is removed from the key switch and the scooter is not in
freewheel mode before performing this procedure.
WARNING! When changing a tire, remove only the center lug nut, then remove the wheel.
If any further disassembly is required, deflate the tire completely or it may explode.
WARNING! Failure to ensure that the axle key is properly installed into the axle slot when
mounting the wheel can result in electronic brake failure, personal injury and/or product
damage.
6. Reinstall the washer and drive wheel nut onto the axle and tighten.
WARNING! Make sure that both the nut and washer are reinstalled and tightened properly.
7. Remove the blocks from beneath the Travel Scooter.
Follow these easy steps for a quick and safe
repair for solid tires :
1. Remove the key from the key switch and
ensure your Travel Scooter is not in freewheel
mode.
2. Elevate the side of the Travel Scooter of which
you are removing the tire. Place wooden blocks
under the frame to elevate the Travel Scooter.
3. Remove the drive wheel nut and washer from
the axle. See figure 28 .
4. Pull the wheel off the axle.
5. Slide the new wheel onto the axle. Make sure
the the axle key is in the axle slot.
AXLE KEY DRIVE WHEEL
WASHER
DRIVE WHEEL NUT
AXLE SLOT
Figure 28. Wheel Replacement