35
Celebrity Deluxe
www.pridemobility.com
I X . B A S I C T R O U B L E S H O O T I N G
What if all the systems on my scooter seem to be “dead”?
Make certain that the key is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See IV. “Your Scooter.”
Make certain that both battery harnesses and the front-to-rear harness are firmly connected. See VIII. “Dis-
assembly and Assembly.”
Be sure the power down timer feature hasn’t been activated. See VI. “Operation.”
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your scooter are designed to help you perform basic troubleshooting quickly and
easily. A diagnostic beep code will sound in the event one of the conditions listed below develops.
NOTE: Your scooter will not run unless the beep code condition is resolved and the scooter has been
turned off, then turned back on.
B EE P CO DE
CO NDITIO N
SO LUT IO N
(1)
Battery charge is low.
Charge batteries as soon as possible.
(2)
Battery charge is too low.
Charge batteries.
(3)
The scooter’s battery voltage is too
high to operate the scooter, or the
charger is still connected to the off-
board charger port.
Unplug charger and/or turn key off, then
back on again.
(4)
Current limit time out.
Turn the scooter off for a few minutes,
then turn your scooter back on.
(5)
The manual freewheel lever is in the
freewheel (forward) position.
Remo ve the key from the key switch,
then push the manual freewheel lever to
the drive (rearward) position, and restart
your scooter.
(6)
Throttle control lever not at center
position at start up.
Return the throttle control lever to centre
position, turn scooter off, then back on.
(7)
Speed pot or throttle control error.
Call your authorised Pride Provider for
assistance.
(8)
M otor volts error.
Call your authorised Pride Provider for
assistance.
(9)
Other internal errors.
Call your authorised Pride Provider for
assistance.