3
Y
our
V
iVa
lift!
™
P
ower
r
eCliner
Figure 2. Chair Assembly
FABRIC CARE INSTRUCTIONS
The fabric covering this piece of furniture is very durable for everyday living. Clean only with water-
based shampoo or foam upholstery cleaner. Do not over wet. Do not use solvents to spot clean. Light
scrubbing will help with any tougher spots that may have developed. Always check a small spot of fabric
in an area that is unseen to be sure the cleaning agent being used will not discolor or fade the fabric’s
finishing. Let the chair air dry and vacuum for the best result.
CHAIR BACK ASSEMBLY
NOTE: If your chair is an Infinite model, refer to the assembly instructions provided with the
chair. For the 2-position model, the KD sleeves are located on the inside as shown in figure 2.
1. Check that the locking clip on the back of the chair is in the vertical position. Reposition if necessary.
2. Drape the hand control and cable over the chair base, then slide the back onto the base. Ensure the
hand control cable is routed through the rear of the chair.
NOTE: Depending on chair width, you may need to slide on one side of the back at a time. If this is the
case, level the chair-back before pressing down to lock into position.
3. Push firmly on the top of the back to lock into position. You must hear a click from each side of the chair to
ensure the back is locked in properly.
NOTE: Pull up on the chair-back to ensure that it is locked in place.
