User Manual (Page 17 of 30)
4. OPERATION
■
Forward / Reverse Selector
Select the desired direction (as marked).
In reverse mode, a warning buzzer sounds automatically.
Release the speed control lever freely while either going forward or reverse, and the
electromagnetic brake in the motor will be activated and the vehicle will stop.
■
Signaling
Before turning, shift the “Turn Signal Switch”, on the handlebar to the desired direction – left for
left, right for right.
The light will flash and buzzer will make a beeping sound when turning the switch to the left or
right.
■
Horn Button
Press the horn button to sound the horn. Release the button to stop the horn.
■
Light Button
Push the light button to switch the front and rear lights on. Push the button again to turn the lights off.
■
Hazard warning
The hazard button operates all flashing lights on the scooter
.
Pushing the button once turns the lights
ON. A second push turns them OFF.
Suggestion
1.
You should recharge the batteries after each time the vehicle is used to ensure maximum range.
The batteries should be charged up at least once a week even if the scooter is not used.
2.
After charging or replacing a new battery, drive the vehicle for 2-3 minutes to make sure the
battery capacity is sufficient.
3.
In wintertime, the battery may respond more slowly and the battery range may be reduced.
4.
When driving on a gradient, the battery indicator light might move up and down. This is
a normal phenomenon so please do not worry.
5. The battery range will be reduced when driving frequently on a slope or rough terrain, as this leads
to greater consumption of power.
6. The electromagnetic brake is automatically locked whenever the operating lever is released and after
the scooter stops completely
