Pride Mobility Quantum Jazzy series, Руководство пользователя

Страница: 26 / 44

26 www.pridemobility.com Quantum Jazzy 1650 Series
V . C O M F O R T A D J U S T M E N T S
Heavy Duty Drop-in Leg Rests
You can adjust the forward/back position, as well as the
length of the heavy duty drop-in leg rests.
To adjust the forward/back position:
1. Remove the adjustment bolt from the side rail. See fig-
ure 15.
2. Move the leg rest hanger in or out to the desired posi-
tion.
3. Align the adjustment holes in the leg rest hanger with
those in the side rail.
4. Reinstall the adjustment bolt to secure the leg rest hanger.
To adjust the leg rest length:
1. Remove the adjustment screws from the leg rest exten-
sion. See figure 15.
2. Slide the leg rest up or down to the desired length.
3. Align the adjustment holes in the leg rest extension and
reinstall the adjustment screws.
Figure 15. Heavy Duty Drop-In Leg Rests
LEG REST
ADJUSTMENT SCREWS
LEG REST HANGER
ADJUSTMENT BOLT
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip wheels are
preset at the factory for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces, it
may be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment if the
following occurs:
!
When coming to a stop, your power chair tips forward excessively.
!
The anti-tip wheels constantly rub the ground.
WARNING! Consult your authorized provider/specialist before attempting to change the anti-tip
wheel height! Changing the anti-tip wheel height affects handling under acceleration!
WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair’s
tendency to tilt forward while decelerating. You can compensate for this by having your authorized
provider/specialist make a small adjustment to the pre-programmed deceleration setting in the
controller or by moving the seat assembly farther to the back of your power chair.
PROHIBITED! Do not remove the anti-tip wheels.
NOTE: Each drive tire must be inflated to 35 psi (2.4 bar) if equipped with pneumatic tires and the user must
also be seated in the power chair in order to properly adjust the anti-tip wheels.