PRG GC RFS, Руководство пользователя

Страница: 31 / 84

GROUNDCONTROL™ REMOTE FOLLOWSPOT SYSTEM™ USER MANUAL
23
Status Menu
+
Log - displays system status log. The log entries are stored in
persistent memory and are retained through power down. Use
touchscreen arrows to scroll up or down. Press CLR to bring up
Clear Log Yes/No options. Press the LOG panel itself to scroll
directly to the bottom, displaying the most recent log entries.
+
Encoders - displays current pan and tilt encoder positions.
+ Reset - press to reset associated fixture and/or camera. (Refer
to "Resetting Fixture or Camera" on page 28.)
+
Info - displays current GC Followspot Controller software
version. Press to open Information Menu .
Press (X) to return to Main Menu .
Information Menu
+
Run Time - displays current run time in
hours:minutes
format.
+
Firmware Versions - displays current firmware versions for the
Truss Box and Switch Board. (In a 4-Way Switch system, this
panel will be blue. Refer to
"4-Way Switch Control" on page 32.)
+
Software Version - displays current GroundControl and Fixture
software versions, along with the Boot version.
+
Crossload - allows the GC Followspot Controller to send its
software version via DMX512 to other connected Controllers in
a daisy-chain. (Refer to
"Software Crossload" on page 56.)
+
Reset Defaults - resets software to factory defaults.
Press (X) to return to Main Menu .
Note: If the associated fixture is changed, recycle power to the GC Followspot Controller (power off and on) to reset
the connection.
Options Menu
+
Intensity Scaling - press to enable or disable intensity scaling.
+
Blackout Button - press to enable or disable the blackout button.
+
Fader Mech Assignments - swaps the function of the two faders
on the control arm between zoom and intensity. (In the default
setting, the front fader controls zoom and the rear fader controls
intensity. With the swap enabled, the front fader controls intensity
and the rear fader controls zoom.)
+
Swap Iris & Zoom - swaps the function of the iris knob and the
zoom fader (whichever fader is currently assigned by the Fader
Mech Assignment).
+ Zoom Table - press to select zoom table setting.
Press (X) to return to Main Menu .