PRETUL 26400, Руководство пользователя

Страница: 7 / 20

7
Maintenance
Buffer set up
• Apply and evenly distribute a spoonful of wax on the
buffer surface.
• Apply in a spiral shape two portions of polish/cleaner on
top the wax previously applied to the buffer. DO NOT apply
the polish/cleaner directly on the buffer.
Polish
• Place the power cord over your shoulder to take it out of
the way while operating the polisher.
• Hold the tool with both hands using the respective
handles.
• Set the polisher base on a flat surface on the car. Push
the switch so the base will start rotating and applying wax.
• Polish as shown in diagram A to cover all the sides of the
car. Use soft and long zigzag movements ( B ).
• Turn off and disconnect the polisher. Remove the buffer
and use it as a glove to apply wax to the parts unreachable
for the tool, like the lower side of the mudguards, the door
handles, etc.
• It is possible that oxidized paint will need more than one
application. Do not use abrasive substances.
• Wax and polish / cleaner in excess will make the
polishing job harder and time consuming. Also, the buffer
useful life will be reduced.
• If the buffer constantly falls out of the holder is possible
the excessive wax or polish / cleaner was applied.
• If the wax does not dilute fast is possible that too much
wax was applied.
3
1
2
4
A
B
• To get the right cooling off, clean the ventilation slots and
keeps them free of obstructions.
• Even tough the buffers are washing machine washable
with cold water a little amount of detergent and medium
temperature, to increase the buffer durability hand washing
and drying is recommended.
• To prolong the useful life and shape of the buffer store
the polisher with the holder facing up.
• To keep the holder dry and with its original shape
remove the buffer from the holder when the polisher is not
being used.
• Use soap and a dry sponge only to clean the polisher.
Clean the housing with a humid cloth if necessary. Do not
use solvents and do not immerse any part of the polisher
in any liquid.
• Carbon Brushes need to be check regularly and when
worn, replaced in a Authorized
Service Center.
• After the carbons have been replaced, ask the technician
to inspect if they run freely in the carbon housing and to
let run the machine 5 minutes to even the contact of
carbon and commuter.
• Use only original carbon brushes,
designed specifically with the strength and electric
resistance needed for each type of motor. Carbon brushes
that are out of the specifications may damage the motor.
• Always change both carbon brushes when replacing
them.
The tool does not have parts requiring maintenance. If the
tool stops working after long working periods take it to a
Authorized Service Center.
Cleansing and care
Carbon brush replacement
Service
ENGLISH
Start up
• Store the tool neatly in a dry place protected from dust
and water.
• For best results, it is recommended to use a 10” diameter
tassel and recommended truper brand accessories such as
Pretul BOR-PULA-P.
Storage