Symptom
Possible Cause / Remedy
Unit not functioning
Units will not Pair - LED
is extinguished after
30 seconds.
• Batteries flat in either transmitter or
CONTROL PRO
- replace.
• Ensure transmitter unit is close to
CONTROL PRO
(eg 1 metre / 1 yard) while pairing.
INSTRUCTIONS
SimplyWorks
®
Pack Contents
Carefully check the contents
of the box, which are:
CONTROL PRO
Two 3.5mm jack
plug cables
This manual
CONTROL
PRO
SimplyWorks is the world’s first fully integrated
wireless system specifically for users with motor
skills difficulties.
SimplyWorks allows you the freedom to create
wire-free, single or multi-user learning environments,
reducing set up time and allowing you to concentrate
on the learning tasks themselves.
CONTROL PRO
may be used with any of the
SimplyWorks transmitters to control toys, lamps, fans
or any battery operated equipment via a standard
3.5mm jack plug. It has two independent channels and
also benefits from two co-operative modes. It can be
used with both wireless and wired switches
simultaneously to afford you the greatest flexibility.
CONTROL PRO
is simple to operate but to ensure you
get the most from your purchase, please take time to
read this instruction booklet.
Your
CONTROL PRO
is warranted against defects in manufacture or component failure. The unit is designed for
domestic and educational applications. Use outside these areas will invalidate the warranty. Unauthorised
repair or modification, mechanical abuse, immersion in any liquid or connection to incompatible equipment
will also invalidate the warranty.
Product Description
If your
CONTROL PRO
does not operate correctly, please use the following guide to determine the cause. If,
after following this guide, your unit still does not operate, please contact your supplier before returning it.
Troubleshooting
Warranty
Unit works erratically
or intermittently
• Batteries flat in either transmitter or
CONTROL PRO
- replace.
• Out of range - move transmitter unit
closer to
CONTROL PRO
.
• Interference - place both transmitter unit and
CONTROL PRO
away from sources of interference.
The output rating of the 3.5mm jack is 1 Amp at upto 30V. Exceeding this rating may cause
permanent damage and is not warranted.
Output Rating
Your
CONTROL PRO
has no user serviceable parts. If repair is necessary the unit should be
returned to Pretorian Technologies or an authorised distributor.
Maintenance
• Not paired with transmitter - follow procedure in
Pairing section.
• Check which channel the transmitter is paired with
and ensure that the output device is connected on the
same channel.
• Batteries flat in either transmitter or
CONTROL PRO
- replace.
Unit 37 Corringham Road Industrial Estate
Gainsborough Lincolnshire DN21 1QB United Kingdom
Tel +44 (0) 1427 678990 Fax +44 (0) 1427 678992
www.pretorianuk.com
SimplyWorks® is a registered trademark of Pretorian Technologies Ltd.
S040016: 1
Refers to firmware
version 37.2 and later
New
Features
Added
