9
7.
Controller Programming / Setup
If the user cannot find a position on the half speed limit switch
control that suits him, the controller can be programmed to meet
his needs. The controller can be programmed in two ways – with
an SP1 Programmer or specialist PC software and interface
cable.
The SP1 is a small hand-held unit which can be plugged into
your controller to alter the program or into the charger socket .
The PC Programmer is a piece of PC software and an interface
cable. When the software is installed onto a PC, it can then be
connected to the controller by using the special interface cable.
The controller can then be programmed using a windows type
environment
The programming tools may be included with your scooter. If
they are not, the scooter distributor or service agent or scooter
manufacturer will are able to program the controller.
If you have a programmer, read the user guide before you use it.
If you re-program your controller, make sure that you observe
any restrictions given in your scooter user manual. Note any
changes you make for future reference.
Programming should only be conducted by healthcare
professionals with in-depth knowledge of PGDT electronic
controllers. Incorrect programming could result in an unsafe
set-up of a scooter for a user. PGDT accept no liability for
losses of any kind if the programming of the controller is
altered from factory pre-set values.
