Presto ARX40, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 24

Page 8 Presto-ECOA Lifts AX, AXR, AXS & AT Series and AL Series
S E C T I O N 3
INSTALLATION
A. INSPECTION
Upon receipt of the AX/AXR/AXS/AXT/AT and AL Scissor Lift, inspect the equipment completely to
determine if there is any damage that occurred during shipment and that the lift is complete. Do not
use the lift if there appears to be any damage. Check the following with the lift in the collapsed position:
1. Check for signs of damage, especially to the Airstroke Actuator™ and pneumatic components.
2. Check all connections and nuts/bolts for tightness.
3. Check base frames for flatness and for bent or damaged metal parts.
CAUTION!
Do not operate the lift before performing the installation procedures specified in section
B. Severe damage to the lift may occur.
B. INSTALLING
Floor Installation
a) Make sure that the floor in the installation area is flat, stable, relatively smooth and free
from dirt, obstacles or surface defects.
b) Place the lift in the exact operating position.
CAUTION!
When moving the lift never attempt to pick it up by the platform. The lift should be picked
up only by the base frame only. The use of a spreader strap/sling is suggested. If the
lift has lifting eyebolts, attach a chain spreader and raise the lift from a center position.
Be sure that the eye bolts are secured in place with locking nuts prior to lifting.
c) Make sure that the complete base of the lift is in contact with the floor. In order to provide com -
plete contact with the floor, the base may be shimmed or grouted.
CAUTION!
Do not spot shim. The complete base must be in contact with the floor or shims.
NOTICE
Machine base lag anchors need to be sized for a minimum of 5000# pull-
out force for each lag.
d) The lift frame must be anchored to the floor using four 3/4" diameter bolts, washers and nuts.
e) Locate and lag down hand control stand or foot control so as to provide easy access. Do not
obstruct the operator's work area. Make pneumatic connections according to the information con -
tained in Section 3C.
CAUTION!
Not lagging the lift base will result in structural damage to the lift.
Pit Mounted Installation
a) Build pit to standard pit dimension as outlined in figure 2, paying careful attention
to raceway, clearance and height requirements.
b) The remaining steps are the same as required for floor installation. See section 3B.
WARNING!
Do not install lifts in pits unless they have an approved bevel edge top and fully exhausting
pneumatic circuit.