33
PRESTIGIO NOBILE 1560
ENG
Corrective
Action
02B0 Diskette drive A error
Drive A: or B: is present but fails the BIOS POST diskette tests. Check to see that the
02B1 Diskette drive B error
drive is defined with the proper diskette type in Setup and that the diskette drive
is attached correctly.
02B2 Incorrect Drive A type -
Type of floppy drive A: not correctly identified in Setup.
run SETUP
02B3 Incorrect Drive B type -
Type of floppy drive B: not correctly identified in Setup.
run SETUP
02D0 System cache error -
RAM cache failed and BIOS disabled the cache. On older boards, check the cache
Cache disabled
jumpers. You may have to replace the cache. See your dealer. A disabled cache slows
system performance considerably.
02F0: CPU ID:
CPU socket number for Multi-Processor error.
02F4: EISA CMOS not writeable*
ServerBIOS2 test error: Cannot write to EISA CMOS.
02F5: DMA Test Failed*
ServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access)
registers.
02F6: Software NMI Failed*
ServerBIOS2 test error: Cannot generate software NMI (Non-Maskable Interrupt).
02F7: Fail-Safe Timer NMI Failed*
ServerBIOS2 test error: Fail-Safe Timer takes too long.
device Address Conflict
Address conflict for specified device.
Allocation Error for: device
Run ISA or EISA Configuration Utility to resolve resource conflict for the specified
device.
Failing Bits: nnnn*
The hex number nnnn is a map of the bits at the RAM address which failed the
memory test. Each 1 (one) in the map indicates a failed bit. See errors 230, 231, or
232 above for offset address of the failure in System, Extended, or Shadow memory.
Invalid System Configuration Data
Problem with NVRAM (CMOS) data.
I/O device IRQ conflict
I/O device IRQ conflict error.
One or more I2O Block Storage
There was not enough room in the IPL table to display all installed I2O block-
Devices were excluded from
storage devices.
the Setup Boot Menu
Operating system not found
Operating system cannot be located on either drive A: or drive C:. Enter Setup and
see if fixed disk and drive A: are properly identified.
Parity Check 1 nnnn*
Parity error found in the system bus. BIOS attempts to locate the address and
display it on the screen. If it cannot locate the address, it displays nnnn. Parity is a
method for checking errors in binary data. A parity error indicates that some data
has been corrupted.
Parity Check 2 nnnn*
Parity error found in the I/O bus. BIOS attempts to locate the address and display it
on the screen. If it cannot locate the address, it displays nnnn.
Press <F1> to resume,
Displayed after any recoverable error message. Press <F1> to start the boot process
<F2> to Setup, <F3> for previous
or <F2> to enter Setup and change the settings. Press <F3> to display the
previous screen (usually an initialization error of an Option ROM, i.e., an add-on
card). Write down and follow the information shown on the screen.
Run the I2O Configuration Utility
One or more unclaimed block storage devices have the Configuration Request bit
set in the LCT. Run an I2O Configuration Utility (e.g. the SAC utility).
If you still encounter problems after going through the corrective measures, please contact your
dealer or an authorized service center for assistance. Some problems may be solved using the
BIOS Setup Utility. See “BIOS Utility” chapter.
Содержание NOBILE 1560
Страница 36: ...36 PRESTIGIONOBILE1560 ENG Notes ...