Prestige PRT 330 LS, Инструкция по эксплуатации

Страница: 7 / 13

5
REVERSING THE DOOR SWING
The door of your Larder Fridge can be reversed.
• Ensure the Fridge is unplugged and empty.
• We recommend you have someone to assist you.
Tools required
• Phillips style screwdriver
• Flat bladed screwdriver
• 8mm Socket or spanner.
• 10mm Socket or spanner.
When laying the Fridge on it’s back in order to gain
access to the base. You should never tip it back
by more than 45º and must rest it on soft foam
packaging or similar material to avoid damaging the
cooling pipes at the rear of the Fridge.
Remove the three screws at the rear and the two
screws at the top of the Larder Fridge and remove
the lid. Lift the hinge bracket out of the recess in the door.
Cover the holes left by the removed screws with
the blanking caps. Resecure the door handle on
the other side. Cover screws with blanking caps Remove blanking plates from the door handle to
reveal screws. Remove the two screws that secure
the handle to remove the it.
Insert top hinge bracket into the recess on top
of the door. Bolt into place using the three bolts
removed earlier.
Replace and secure the lid of the Larder Fridge
with the two top screws and the three rear screws
from step one.
Use an 8mm spanner to remove the bolts from the
top bracket.
Lay the Larder Fridge backward. Remove the
bottom hinge bracket using an 8mm socket or
spanner. Remove the pin from the bracket with a 10mm
spanner/socket. Replace in the same hole through
the other side. Remove the door.
Remove the pin and replace on the opposite side
using a 10mm socket or spanner. Reattach bottom
bracket to the Larder Fridge. Replace levelling feet.
Stand upright and replace door.
Check the door is
aligned horizontally
and vertically.
Re-adjust the levelling
feet. See ‘Levelling
the Larder Fridge’ on
page 2.
9 12
1 2 3
8
7 5 4 6
11