128-9449
Page 2
Page 2
TIMED START PROGRAM:
The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This
feature is useful in extremely cold climates where starting the engine is the only means to keep
the battery charged and fluids warm. The operator has the option to have the unit start every 2
or 4 hours for a maximum of 48 hours. Factory preset is to start at 4 hour intervals. To select 2
or 4 hour automatic start timer:
1. Start By Holding the Push Button Switch found on the windshield mount receiver on.
2. While Holding the Push Button Switch Turn The Ignition Switch On Then Off
3a) Within 10 seconds of turning the ignition switch off, Release and then Push On and release
the Push Button Switch 2 times holding it on the second time until the siren and or lights flash
and chirp 2 times indicating that the 2 Hour Start Interval has successfully been set. or
3b) Within 10 seconds of turning the ignition switch off, (Step 2) Release
and then Push On and release the Push Button Switch 4 times holding it on the fourth time until
the siren and or lights flash and chirp 4 times indicating that the 4 Hour Start Interval has suc
-
cessfully been set.
NOTE: Once selected, 2 or 4, this timer interval will remain in memory until it is manually
changed. To change, the above sequence will have to be followed.
TIMED START OPERATION:
To begin the start timer, within 10 seconds of turning off the ignition switch, activate the RF com-
mand to start 2 times. (Press the start button four times). The lights will flash and the siren will
chirp 4 times. Indicating timed interval mode has been initiated. The vehicle will automatically start
every 2 or 4 hours as programmed. To cancel the timed start mode start the vehicle either by RF
or by the ignition key.
REMOTE START OVERRIDE MODE / MANUAL SHUT DOWN:
The intent of the remote start override / manual shut down circuit is to allow the vehicle operator to
prevent operation of the Remote Start Unit regardless of the RF transmitter operation.
To Enter The Remote Start Override Mode:
1) With the system disarmed/unlocked, and the ignition switch off Press and Hold the pushbutton
switch located on the receiver unit on.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED begins to flash two short flashes followed by one long flashes and continues this
pattern until returned to normal mode of operation.
The action above puts the unit into the Remote Start Override mode or vehicle service mode
and will not start from the RF transmitter or any other input.
To Exit Remote Start Override Mode:
1) With the system disarmed, Press and Hold the PBLED on.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED turns off indicating that the R/S unit is fully functional one again.
Programming New or Replacement 141BP Transmitters:
