128-9350
3 of 4
PROGRAMMED TRANSMITTER NOTIFICATION (PTN)
Every time after Disarm, when the ignition key is turned on, the unit's LED will re-
port the number of transmitters programmed into the system. This safety feature
will alert you if an unauthorized transmitter has been programmed into your
vehicle's security system without your knowledge. Typically from the factory,
there will be 2 flashes and a pause, repeated 3 times, indicating that two trans
-
mitters are programmed into the system. If you note additional flashes, an addi
-
tional transmitter may have been added without your knowledge or authorization.
If you notice a change in the transmitter LED report pattern, you can correct this
by looking up how to erase and reprogram your transmitters found in the trans-
mitter programming guide. This reprogram operation will erase all unauthorized
or unwanted transmitters.
PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1)
Transmitter Model Name 3BP Is Also Found On Back Of Transmitter Case
And Uses CR2032 Battery.
1) Turn the ignition key to the ON position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Press the Lock Button of each transmitter you want programmed until you hear
a chirp from the horn or siren.
4) Turn the ignition switch to the OFF position.
The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons
which are typical for most systems.
For additional channel programming beyond the 1 option button, you can use any
unused button or combination of buttons not in use. In other words, to access option
channel 5, 6, 7, you would do the following:
From step 3 above:
a) Press and release the valet/programming button 4 additional times to get to
channel 5, then Press any unused transmitter button or button combination to
program.
b) From a, press and release the valet/programming button 1 time to get to channel
6, then press any unused transmitter button or button combination to program.
c) From b, press and release the valet/programming button 1 time to get to channel
7, then press any unused transmitter button or button combination to program.
NOTE:
Not all systems have channels above 3, check with your installation center
for options your system may or may not have.
NOTE:
Certain systems have the ability to utilize channels 6 & 7 for driver priority
programming. For driver priority, the vehicle must be equipped with this feature,
and the optional feature must be set up and installed by your installation center.
Once this feature is added when the unlock button of transmitter 1 is used, it will
set driver 1 priority, and when the unlock button of transmitter 2 is used it will set
driver 2 priority. In this situation, the unlock button can be programmed into two
receiver channels, unlock, channel 2 and driver priority 6 or 7. In no other circum-
stance will the system allow a transmitter button to be programmed into 2 receiver
channels at the same time.
