128-9309 of
24 of 24
Page 24
© 2014 Voxx Electronics Corporation. 150 Marcus Blvd. Hauppauge, NY 11788 128-9309A
To purchase replacement transmitters
or to get additional product information go to:
www.prestigecarsecurity.com
PATENTED: www.voxxintl.com/company/patents
PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1)
Transmitter Model Name 145SP or 5BCR14SP Is Also Found On Back Of
Transmitter Case. Use Battery CR2032 For 145SP & AAA For 5BCR14SP.
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Press the Lock Button of each transmitter you want programmed until you hear a chirp
from the horn or siren.
4) Turn the ignition switch off.
The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons which are
typical for most systems.
For additional channel programming beyond the option 1 button, you can use any unused
button or combination of buttons not in use.
In other words, to access option channel 5, 6, 7, you would do the following:
From step 3 above:
a) Press and release the valet/programming button 4 additional times to get to channel 5,
then press any unused transmitter button or button combination to program.
b) From a, press and release the valet/programming button 1 time to get to channel 6, then
press any unused transmitter button or button combination to program.
c) From b, press and release the valet/programming button 1 time to get to channel 7, then
press any unused transmitter button or button combination to program.
NOTE:
Not all systems have channels above 3, check with your installation center for options
your system may or may not have.
NOTE:
Certain systems have the ability to utilize channels 6 & 7 for driver priority programming.
For driver priority, the vehicle must be equipped with this feature, and the optional feature
must be set up and installed by your installation center. Once this feature is added when the
unlock button of transmitter 1 is used, it will set driver 1 priority, and when the unlock button
of transmitter 2 is used it will set driver 2 priority. In this situation, the unlock button can be
programmed into two receiver channels, unlock, channel 2 and driver priority 6 or 7. In no
other circumstance will the system allow a transmitter button to be programmed into 2 receiver
channels at the same time.
This unit's transmitters can control two vehicles with Prestige Remote Systems. To toggle
primary or secondary vehicle press lock and trunk/key buttons simultaneously for 5 seconds.
Transmitter Battery Replacement
1) Locate and remove the "00" point Phillips head screw on the back of the transmitter
case.
2) Carefully separate the front case from the rear.
3) Slide the CR2032 battery out from under the battery clip and dispose of properly.
4) Install the new battery with the (+) side facing up away from the circuit board.
5) Close the case and reassemble in reverse of disassembly
