128-9311
3 of 4
To place the system in the service mode:
1. With the system disarmed/unlocked, and the ignition switch off, Press and Hold the
Push-Button, found on the windsheild receiver, in.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED begins to flash two short flashes followed by one long flash and continues this
pattern until returned to the normal mode of operation. This puts the unit into the R/S
Override mode indicating that the remote start is in the service mode and will not start
from RF or any other input Posse or otherwise.
To Exit R/S Override Mode:
1. With the system disarmed, Press and Hold the Push-Button, found on the windsheild
receiver, in.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED turns off, indicating that the R/S unit is fully functional once again.
PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS
(BANK 1)
The Transmitter Model Name, 143BP, Is Also Found On The Back Of
The Transmitter Case (Battery Use CR2032)
1. Turn the ignition key to the on position.
2. Press and Release the Valet/Programming switch 3 times (Siren Chirps).
3. Press the Lock Button of each transmitter you want programmed until you hear a chirp
from the horn or siren.
4. Turn the ignition switch off.
The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons which are
typical for most systems.
For additional channel programming beyond the 1 option button, you can use any unused
button or combination of buttons not in use.
In other words, to access option channel 5, 6, 7, you would do the following:
From step 3 above:
a. Press and Release the Valet/Programming button 4 additional times to get to channel 5,
then Press any unused transmitter button or button combination to program.
b. From step a, Press and Release the Valet/Programming button 1 time to get to channel 6,
then Press any unused transmitter button or button combination to program.
c. From step b, Press and Release the Valet/Programming button 1 time to get to channel 7,
then Press any unused transmitter button or button combination to program.
NOTE:
Not all systems have channels above 3, check with your installation center for
options your system may or may not have.
This remote has the ability to operate 2 Audiovox Alarms From A Single Transmitter. To toggle
on and off vehicle one or two,,,
Press the Trunk/Key the Lock button for 5 seconds.
The LED flashes 2 times. Release the buttons, to select 2nd vehicle mode. Program this
transmitter into the second vehicle's system. Any time you are in 2nd vehicle when the
transmitter is operated, the LED will flash twice for each function. When in the prime vehicle
mode, the LED will flash once for each function.
