128-9348
3 of 4
factory, there will be 2 flashes and a pause, repeated 3 times, indicating that
two transmitters are programmed into the system. If you note additional flashes,
an additional transmitter may have been added without your knowledge or
authorization. If you notice a change in the transmitter LED report pattern, you
can correct this by looking up how to erase and reprogram your transmitters
found in the transmitter programming guide. This reprogram operation will erase
all unauthorized or unwanted transmitters.
PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1)
The Transmitter Model Name, 1BP, Is Also Found On The Back Of The
Transmitter Case And Uses A CR2032 Battery.
1. Turn the ignition key to the on position.
2. Press and Release the valet/programming switch 3 times (Siren Chirps).
3. Press the Button of each transmitter you want programmed until you hear a chirp
from the horn or siren, or the parking lights flash.
4. Turn the ignition switch off.
The above action programs the Start button in a 1 button system.
Transmitter battery replacement:
1. Locate the slot along side the transmitter case and using a plastic tool or this
coin, separate the two transmitter case halves.
2. Slide the CR 2032 battery from the battery holder paying attention to the battery
orientation's (+) side facing away from the circuit board.
3. Replace the battery with a new one.
4. Reassemble the case in reverse order of disassembly.
FUNCTION SETTING CHART
To be completed by installer
Run Time
_______Min
Door Lock Timer
_______Sec
Parking Lights
Pulse
Steady
WARNING!
A running vehicle produces dangerous carbon monoxide gas which can
be fatal if prolonged exposure occurs. Be certain the vehicle is outdoors
before activating the remote start function.
