PRESONUS CDL Series, Руководство пользователя, Страница: 17 / 28

3 Hookup
3.1 Rear-Panel Connections and Controls
CDL-series
Owner’s Manual
13
3 Hookup
3.1 Rear-Panel Connections and Controls
Line Input. This is a balanced XLR connection for line-level input. Use the Line input
to connect the loudspeaker to a StudioLive digital mixer or another mixing console,
either directly or through the Line out connector on a CDL-series loudspeaker.
Direct Out. This is the Direct Out for the line input. Use this to connect to other
CDL-series loudspeakers.
See Section 3.4 for a connection example.
Dante / Control. This locking Ethernet connection can be used for control via the
Worx Control application as well as Dante audio networking. A standard RJ45
connector may be used, but we recommend the protection provided by using the
mating male locking Ethernet connector.
For more information on creating a wired
LAN network and using Dante, see the Worx Control Reference Manual.
Preset Toggle. This button toggles between Preset 1 and Preset 2.
• CDL12. Use Preset 1 when using (1) CDL12 loudspeaker and
Preset 2 on both loudspeakers in a (2) CDL12 array. When using
3 or more CDL12 loudspeakers in an array, you must use Worx
Control Software to load the presets for larger configurations.
• CDL18s. Use Preset 1 when using (1) CDL18s subwoofer with (1) CDL12
loudspeaker. Use Preset 2 for applications requiring a higher subwoofer output.
High Pass Filter (CDL12). This button enables/disables the 90 Hz High Pass Filter.
When the LED is illuminated, the 90 Hz High Pass Filter is active. When active,
frequency content below 90 Hz is removed.
Polarity (CDL18s). The Polarity button inverts the polarity of the input signal. The
LED will illuminate to indicate that the polarity is inverted.