10
This document contains information and data which is proprietary to Presidio that shall not be duplicated, used, or disclosed - in whole or in part
- for any purpose other than to evaluate this product.
AIO3.0 User’s Manual
PRES058-150422 REV 4
After confirming the device is fully functional select an intended installation location that will assure the
device can be securely fastened to the vehicle and that the device has the least obstructed view of the sky.
The device comes with an auxiliary mounting case that comes with internal magnets that will support
most installations. For those cases where a magnet will not secure the device one can use tie-wraps or
whatever other appropriate means to secure the device to the vehicle. The installation location is vehicle
dependent however care should be taken that the GPs and Cellular antennas must be located facing away
from the mounting structure. Position the GPS antenna (Side with the three LED’s) so that it is not
obstructed with metal. Some installation locations may require that the device be pointing towards the
ground.
3.1.2
Non-Vehicle Installations
As above, confirm the device is fully functional before installation. Installation locations are based on the
asset structure and the same care should be taken to provide the least amount of obstruction to the GPS and
Cellular antennas within the device. Do not install the device within a total metal container or structure.
3.2
OPERATING PROCEDURES
After the Device has been set-up, tested, and installed it is monitored and controlled by the mapping
application. Refer to the Map AGenT Users Guide for complete operating and tracking
functions of the AIO3.0.
3.3
PROBLEM PROCEDURES
There are no user servable parts within the AIO3.0 device. It is imperative that the device be tested prior
to deployment to ensure the unit is fully functional. If the AIO3.0 fails during deployment confirm the
device is powered on and that the battery is charged. If so try to communicate with it using the mapping
application, if you are successful than most likely the installation location may have caused the unit to
not function properly. Select a new installation location and test unit as necessary.
3.4
MALFUNCTIONING GPS
If during deployment the device does not report a navigation report and it is known to have worked prior
to deployment then in most cases the GPS antenna is blocked and the unit cannot receive adequate signal
to calculate position. Several external factors can cause this issue which may or may not be resolved
once the vehicle moves from its current position. If the device continues to not report position data then
the device has malfunctioned and it should be removed and returned to Presidio for evaluation and/or
repair.
