PRESIDENT MC-8050 DSC, Руководство пользователя

Страница: 34 / 48

34
When the GPS receiver is correctly connected, the display shows GPS Data OK. If there is a
problem with the GPS connection, the display shows Check GPS. When the display shows
GPS Data OK
, press ent-1W/25W to open the GPS status screen and see detailed GPS
data:
16
06/20 11:00:00
208
o
30. 0 KT
35
o
40. 610 N
139
o
46. 564 E
Date
Time
Current
channel
Course
Latitude
Longitude
Speed
Configuring the GPS
If the radio is receiving valid GPS data, it will automatically set the clock to your local time
based on the GPS location. You can adjust your local time forward or back one hour if nec-
essary (for example, if you are close to the border of a time zone); you can also adjust for
Daylight Savings Time.
Follow the steps below to adjust the time:
Use the up and down arrows
to adjust the time by
one hour.
16
Back[CLR] Select[ENT]
Time Adjust
09 : 14
Setup
Press and hold -
GPS Setup
Time Adjust
1. Display the normal menu and choose the Setup sub-menu.
2. Select GPS Setup and then choose Time Adjust .
3. The display shows your current local time. To adjust the time forward one hour, use
CHAnneL UP . To adjust the time back one hour, use CHAnneL DoWn button. Press
ent- 1W/25W button when you are finished.
4. The display prompts you to confirm the setting: choose
Set
to save the new time or
Cancel to exit time setup without saving. The radio returns to the GPS Setup menu.
5. If your local area observes Daylight Savings Time, choose Daylight Save and press the
ent-1W/25W button.
6. If Daylight Savings Time is currently in effect, select
On
. If Daylight Savings Time is not
currently in effect, select Off .
7. Press ent-1W/25W . The radio activates the new time setting and returns to the GPS
Setup menu.
Connecting to a Chartplotter
Your radio provides a standard NMEA0183 GPS output that you can connect to a chartplot-
ter. When it receives another boat’s position data in a DSC call, the radio sends the position
data to the chartplotter so you can see the location:
1. Connect the BROWN wire of the accessory cable to the NEGATIVE (-) wire of your
chartplotter’s NMEA data INPUT.