4. From underneath, slide the gasket and
washer and screw the retaining ring
over the end of the copper pipe and
up to the exposed threaded section of
the faucet. Tighten the retaining ring by
hand until it is snug. Using a wrench or
pliers, tighten the assembly.
5. Gently tighten the two screws on the
retaining ring. Do not over tighten.
6. Screw the sprayer head onto the
gooseneck pipe.
7. Connect the water supply line (not
supplied) to the faucet.
Strainer Installation
1. Apply a ring of plumber’s putty or
sealant (not included) to the underside
of the flange on the strainer body. Insert
the strainer body into the utility sink [B].
2. Assemble the rubber gasket, friction
washer and locknut onto the strainer
body from underneath the utility sink.
Hand tighten the locknut.
CAUTION: Do not over tighten the
locknut or the connecting nut, as
this may split or deform the strainer
body.
3. Connect the plastic flange and tail
pipe (not supplied), then thread the
connecting nut through the tail pipe and
plastic flange up to the lower threaded
part of the strainer body. Tighten the
connecting nut by hand.
Sink Installation
1. Carefully place a bead of sealant all
around the top of the cabinet [A].
B
A
Sealant
Sprayer
head
Gooseneck pipe
Faucet body
Faucet handle
Gasket
Washer
Threaded section
Retaining ring
Screws
Strainer
basket
Strainer
body
Strainer
body
Rubber
gasket
Friction
washer
Locknut
Plastic
flange
Tail pipe
(not supplied)
Connecting nut
Plumber’s putty
or sealant
