11
CONGLOMKB .COM
Please contact customer .service@conglomkb .com or 1-877-333-0098 for further assistance .
Installation (continued)
INSTALLING THE VANISHING EDGE
TM
STRAINER
F
G1
G2
G3
G4
G5
1
2
3
Not supplied
Not supplied
NOTE:
If you are installing a garbage disposer (not supplied), do not install the strainer.
You will need to purchase from Conglom Kitchen & Bath, an adaptor. This will
replace the flange from your garbage disposer.
Install the garbage disposer according to the manufacturer’s installation
instructions replacing the flange for the adaptor.
- Apply a small amount of plumber’s putty (not included) in the notch
around the drain hole of the sink .
- Connect the upper strainer body (G2) and the strainer ring (G3), and
insert them into the drain hole from the top of the sink .
- Connect the strainer gasket (G4) and lower strainer body (G5), and
insert them into the drain hole from underneath the sink .
- Insert the strainer screw (G1) through the entire assembly, from the
upper strainer body (G2) to the lower strainer body (G5) . Tighten with
a Phillips screwdriver .
-
Connect the plastic flange (1) and tail pipe (2), and thread the
connecting nut (3) through the tail pipe and flange up to the lower
strainer body (G5) . Lock the connecting nut by hand .
NOTE:
The plastic flange (1), tail pipe (2), and connecting nut (3) are not supplied.
