Prentke Romich Company Optical Headpointer, Инструкция по монтажу

Страница: 17 / 18

Replace the Liberator Headpointer Cable
At some point you may have to replace the cable in the Liberator Headpointer. The wires may become
frayed or disconnected, or for some other reason the headpointer may quit working. To order a
replacement cable, call the PRC Sales Department at 1-800-262-1933 and ask for part number 11115.
When you receive your new cable, take your headpointer and turn it so that the slender end (the stem) is
facing you. Unscrew the bottom part of the stem (the part of the headpointer that the cable goes into).
When the old cable is unscrewed from the headpointer, gently pull the cable wires out of the back of the
headpointer until you see a small white connector. The Liberator cable wires are attached to the bottom
of this connector. The rest of the headpointing wires are attached to the top of the connector. Using
your fingernails, pull the very bottom part of the connector away from the top part of the connector.
(See bottom illustration on facing page ) The cable should now be disconnected from the connector.
Throw the old cable away.
Plug the white connector end of the new cable into the place on the headpointer connector where you just
disconnected the old cable.
The cable connector only attaches to the headpointer connector in one way. If you try to push the two
ends together and they don' t connect, turn the
cable connector over and try again. When the cable and
headpointer are connected, push the wires back into the headpointer stem. Screw the bottom piece of the
headpointer back onto the stem. Plug the other end of the cable into the Liberator.
Your headpointer is now ready to use.