Premium PFR102G, Инструкция по использованию и уходу, Страница: 3 / 9

△
Use soft cloth with water or a little detergent to clean the out surface. Note, keeping the
power supply and lower part of connect wires away from water to avoid electricity leakage.
△
Except common breakdowns, those who are not service technician should not take apart and
repair the freezer on their own so as to avoid worsening the trouble. Unauthorized repair of
electrical part such as compressor, temperature controller is forbidden.
Defrosting
△
Defrost for better freezing efficiency when the frost film in the cabinet is 4-5mm thick.
△
When defrosting, turn off the power, take out the frozen foods, open the door for warming
and melting. Use soft cloth to absorb water and clean it up.
△
Do not use sharp metal tools such as steel brush to clean the frost film when defrosting so as
to avoid evaporator damage.
Trouble shooting
Breakdown Case Removal method
The plug isn’t connected to the
socket really.
Replug it. The indicator is not on.
The compressor doses not start.
no power Connect the socket with power.
The indicator is on ,but the com-
pressor doesn’t work and buzzes
only
The power voltage is
＜
98V.
The compressor stops a minute
after start, and restart after a few
minutes, and so repeatedly.
The power voltage is
＞
132V.
Put a power-regulater more than
1000W power together.
The door is opened too frequently. Reduce open times.
The food in the cabinet is too
much, and placed improperly.
Place foods properly keep place
between them for ventilation of
cold air.
The frost film is too thick. Take out foods and defrost.
The surface of the condenser is
too dirty.
Stop and clean the condenser.
The compressor works normally,
but the temperature in the cabinet
lowers too slowly.
The door seals badly. Adjust the door seal.
The freezer is placed unstably. Place it stably.
The fixing of the freezer is loose. Tighten the fixing. The noise is too loud
there’s contact between pipes. Separate them.
The following are not faults:
△
When the freezer is working or after is stops for a while, the refrigerant in the pipes is cycling
and gives out
＂
running water
＂
sounds.
△
The surface temperature of the compressor may be up 70
℃
~80
℃
when it is working.
△
The back side of step freezer gives out heat.
△
In rainy season, the outer surface of the cabinet may have dew, which makes no defects on
normal use. Just dry it with a piece of cloth.