Premium ALESSA, Инструкция по эксплуатации

Страница: 3 / 61

Mounting of your device should be performed with mounting accessories inside the product package. All
fittings available in the mounting accessories should be used in order to complete the safe mounting of your
device. Unlike, materials such as adhesives, screws, nails etc. should not be used.
When mounting your device, the mounting template inside the mounting accessories should be used. The
minimum height of your device from the cooker surface should be 75cm in gas cookers and 65cm in electric
cookers. If gas cookers and electric cookers are used together, the minimum distance should be 75cm.
The device should be mounted on the wall on a flat surface.
Air escape pipe should not be connected to the chimneys containing waste gas such as gas heater,
thermosiphon, combi boiler, heating stove and fireplace and a minimum Ø120mm air escape pipe should be
used. Also, if it is not a specially designed opening, the outlet air should not be given to the wall opening.
This warning does not apply to devices used without a chimney (carbon filter).
The air escape pipe should be as short as possible and have few elbows. This warning does not apply to
devices used without a chimney (carbon filter).
If adequate ventilation is not provided when your device is in operating state, vacuum will be generated as
your device will draw the ambient air. In this case, the gases of other products used as chimney and
containing waste gas (gas heater, thermosiphon, combi boiler, heating stove, fireplace, etc.) may enter the
ambient again and cause poisonings. The negative pressure in the room should be at most 4 Pa (0.04
mbar). This warning does not apply to devices used without a chimney (carbon filter).
The flaps at the outlet of the chimney on your device should be in the open position when the motor is
running and in the off position when the motor is not running. The negativities that prevent this situation
should be removed. This warning does not apply to devices used without a chimney (carbon filter).
The electrical connection should not be made before the mounting of your device is completed.
If the power supply cable is damaged, the mounting of the device should not be performed and a new one
should be supplied from the authorized service and be replaced.
The operating voltage of your device is 220-240V and should be connected to a grounded power network.
If there is a supply cord and plug in your device, the device should be mounted so that the plug can be easily
reached.
If your device is to be connected directly to the electric network, it is necessary to place a switch between the
device and the network, of which minimum clearance between the contacts is 3 mm and dimensions are in
accordance with the load and the law in force.
During the mounting, the supply cable should not be exposed to heat, jamming or crushing.
For your safety, the "MAX 6A" fuse should be used in the device connection wiring.
After the mounting of your device is completed, the white and/or transparent protective foil on the inox
(stainless) surfaces should be removed without damaging the product.
The device should not be operated without a filter. The filters should not be removed from their places when
the device is in the operating state.
The filters in your device sould be replaced and/or washed in the specified periods. Filters that are not
replaced and/or washed on time are have the risk of fire due to oil deposits on them. In addition, these oil
deposits will reduce the performance of your device.
Before cleaning or maintaining, it should be waited for the cooling of the device. The fuse should be switched
off or the electric outlet should be unpluged.
When cleaning the interior of the cooker hood, it should be very careful and gloves should be worn.
Non-flame-resistant filtering materials should not be used instead of filter. The original filters of the producer
company should be used.