Tip:
If the seat
back is a little
tight going into
the seat base,
partially loosen 2
of the seat
screws to allow
the base legs to
open, insert the
seat back and
then re-tighten
the screws.
G
F
b
x4
G
b
x1
a
x1
e
E
6.
Attach Part G to Part F
using 4 of hardware b.
Tip:
When installing the chair bolts in Steps
6 & 7, insert the bolt into the hole, align it
with the nut and finger-tighten the bolt a
couple of turns into the nut before driving
with a drill. This will help to reduce the risk
of cross-threading.
7.
Turn the back/seat assembly on
it's side. Lay one arm/leg assembly
from steps 1-5 on the back/seat
assembly and bolt together using 1
each of hardware a & b as shown.
Flip the chair to the opposite side
and repeat.
8.
Assemble Part E into the chair. Insert
the tenon into the slot in one leg. Then
with slight pressure on the opposing leg,
push the opposite side of Part E into its
corresponding slot. Screw in place using 2
of hardware e.
4
AD-0101 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com
