Premium Leisure Dual Zone 18, Руководство пользователя

Страница: 39 / 63

Page 37
For HELP, call 727.573.9611
to prevent the spa water from becoming stagnant in the plumbing and air lines
and improve skimming action to remove debris and suspensions from the water
surface. In addition, the programmable filtration cycle (start/end) times of each
cycle will designate the start and end time where the heater is allowed to operate
in economy and sleep modes. Sleep mode heats the spa water to within 20 F
(11 C) of the set temperature only during filter cycles. The “Sleep” icon will
display until mode is changed.
Standby Mode: Pressing “Warm Arrow Up” or “Cool Arrow Down” then “Jets2”
button will turn off all spa functions temporarily. This is helpful when changing
filter cartridges. Press any button to exit Standby mode.
Jets 1 Button
Press the “Jets 1” button once to turn pump 1 on or off. If left running, the jet
turns off after 15 minutes.
Jets 2 Button
Press the “Jets 2” button once to turn pump 2 on or off. If left running, the pump
2 turns off after 15 minutes.
Aux Button (Jets 3)
Press the “Aux” button once to turn pump 3 on or off . If left running, the pump
turns off after 15 minutes.
Light Button (If Equipped)
Press the “Light” button to turn the spa light system on and off. The LED light
system is preprogrammed with an assortment of lighting effects. When you turn
Light off and turn on again within five (5) seconds, it advances to the next effect.
When you turn Light off for more than five (5) seconds, it remembers that last
effect you selected. The next time you turn on the Light will display the same
effect. The Light will automatically turn off after approximately four (4) hours.
Time Button
Once your spa has been properly connected the first time the “Time” icon
appearing on the screen and flashing. Press “Time” pad, then “Mode.” Select the
hour by pressing “Warm” or “Cool” (each press changes time by 1 hour). Press
“Mode” pad again and select minutes by pressing “Warm” or “Cool” (each press
changes time by 1minute). Press “Mode” pad to exit the time setting procedure
and enter the optional filter cycle programming. Press “Time” pad to exit
programming. The Time setting on 2000 systems is not preserved in the event of
power loss; time will have to reprogram upon each power up.
Inverting the Information Display Area Readout
Press “Warm Arrow Up” or “Cool Arrow Down” button, followed by the “Aux”
button to change the numbers in the display to read upside down.