FlacheSAN1N6C-D4 Quick Guide
For more information please visit our website at
www.premioinc.com
Copyright © 2017, Premio Inc. All rights reserved.
5.
Remove the top cover
to install or inspect the
internal of the system.
6.
Inspect the internal
of the system. By default, it
consists of an Asrock EP2C612D16FM Haswell Dual Processor
motherboard, a set of CPU and memory, a switch board, 3x
blower modules. Optionally, OS drive (up to 2x), IOM card
(Gen3x8), NVMe cards (Gen3x4 each) and Expansion cards
(Gen3x16 each) are installed by request.
PSU
Switch
Board
OS Drive
x2
Blower
x3
Motherboard
NVMe #6
(bottom)
NVMe #5
(
top
)
NVMe #2
(bottom)
NVMe #1
(
top
)
Exp. card #1 (top)
Exp. card #2
(bottom)
CPU2
CPU1
IOM Card
NVMe #4
(bottom)
NVMe #3
(
top
)
NVMe #1 to #4 and Expansion card #1 are associated with
CPU1. NVMe #5, NVMe #6, and Expansion card #2 are
associated with CPU2. IOM card is connected to CPU1.
7.
Install CPU and memory
(may be sold separately)
to their respective slots on the motherboard. Please be aware
of each component’s installation requirements and
prerequisites. Refer to the motherboard’s TPS for details.
Processor:
·
Intel Xeon E5-2600/
4600 v3/v4 series CPU
·
Dual Socket LGA 2011
R3
·
Intel C612 Chipset
Memory:
·
16 DIMM slots
·
Quad channel memory
·
DDR4 2400*/2133/
1866/1600 RDIMM and
LRDIMM
·
1.2V
·
RDIMM: 32, 16, 8, 4GB
·
LRDIMM: 64GB, 32GB
* Only for E5-2600 v4
8.
Install OS disk(s)
into the bracket as follows:
1. Remove the OS disk bracket
2. Install the OS disk and
secure with M3 screws
(red circles)
3. Place the disk bracket assembly
back to the enclosure
4. Install the SATA and power cables to the disks
9.
Replace the top cover.
Once we are finished with
the internals of the system, close the top of the chassis.
10.
Prepare rack mounting
by installing inner rail to
the enclosure.
1. Install stand-offs (yellow circles) when necessary
2. Secure inner rail with M4x4L screw (red circle)
Install the outer rail to the rack. Use 6-32 x16L screws to
secure the rail (red circles, for rear posts only).
1U
11.
Mount the enclosure
to the rack. Secure the
enclosure with 6-32 x16L by the ears.
1. Slide the inner rail of the enclosure
to the outer rail of the rack
2. Pull the latch (red circle) to
push the unit all the way
12.
Plug in the power cords
to the AC receptacles
on the back of the unit and secure it with the wire lock.
13.
Press the power button
on the
front of the unit after connecting a monitor
and input devices, and get ready for
software setup.
